REAR WIPER MOTOR INSTALLATION

PROCEDURE

1. INSTALL REAR WIPER MOTOR GROMMET

   
   
   1. 

      *a	Lip Portion

      Apply MP grease to the entire circumference of the lip portion of the rear wiper motor grommet.

      Tech Tips

      Do not fill the hole with MP grease. Only apply MP grease to the grooves of the lip portion.

   2. 

      *a	Alignment Mark

      Install the rear wiper motor grommet with its alignment mark aligned with the top of the vehicle.

2. INSTALL REAR WIPER MOTOR ASSEMBLY

   
   

   1. Install the rear wiper motor assembly with the 3 bolts.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

   2. Connect the connector.

3. INSTALL REAR WIPER ARM AND BLADE ASSEMBLY

   
   
   1. 

      *a	Rear Wiper Arm Serrations
      *b	Rear Wiper Motor Assembly Pivot Serrations

      When reinstalling:

      
      

      1. Clean the rear wiper arm serrations.

         Note

         Do not grind the rear wiper arm serrations.

   2. Using a wire brush, clean the rear wiper motor assembly pivot serrations.

      Note

      Do not grind the rear wiper arm serrations.

   3. Turn the engine switch to ON.

   4. Operate the rear wiper motor assembly and stop at the automatic stop (park) position.

   5. Turn the engine switch off.

   6. 

      *a	Alignment Mark

      Align the alignment mark of the back door glass sub-assembly with the edge of the rear wiper arm and blade assembly to install the rear wiper arm and blade assembly.

   7. Install the nut.

      Torque:

      5.5 N*m  { 56 kgf*cm, 49 in.*lbf }

      Tech Tips

      Hold the arm hinge by hand when tightening the nut.

   8. Operate the rear wiper motor assembly while spraying washer fluid on the glass. Make sure that the rear wipers function properly and the wipers do not come into contact with the vehicle body.

   9. Raise the rear wiper arm 2 times and check that the tip of the rear wiper blade is within the range shown in the illustration.

4. INSTALL REAR WIPER ARM HEAD CAP

   
   

   1. 

      Attach the 2 claws to the rear wiper arm and blade assembly.

   2. 

      Attach the 2 claws to install the rear wiper arm head cap as shown in the illustration.

5. INSTALL BACK DOOR TRIM BOARD ASSEMBLY

   Click here

6. INSTALL BACK DOOR LOCK COVER (w/ Power Back Door)

   Click here

7. INSTALL BACK DOOR LOCK COVER (w/o Power Back Door)

   Click here

8. INSTALL BACK DOOR TRIM BASE (w/ Power Back Door)

   Click here

9. INSTALL PULL HANDLE (w/ Power Back Door)

   Click here

10. INSTALL BACK DOOR FINISH COVER LH (w/o Power Back Door)

    Click here

11. INSTALL BACK DOOR FINISH COVER RH (w/o Power Back Door)

    Click here

12. INSTALL BACK DOOR SIDE GARNISH LH

    Click here

13. INSTALL BACK DOOR SIDE GARNISH RH

    Click here

14. INSTALL BACK DOOR CENTER GARNISH

    Click here