ROOF SUNSHADE SYSTEM DATA LIST / ACTIVE TEST


  1. DATA LIST

    Tech Tips

    Using the GTS to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.

    Note

    In the following table, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / (desired system) / Data List.

    6. Read the Data List according to the display on the GTS.


      1. Sliding roof drive gear assembly (front roof sunshade ECU):


        Body Electrical > Sliding Roof > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        Front SW Auto Operation Roof sunshade auto function ON or OFF Customization status displayed -
        Hall IC1 Pulse Hall IC1 pulse output Lo or Hi Lo and Hi repeat during motor operation

        Lo: Hall IC1 output is low

        Hi: Hall IC1 output is high
        Hall IC1 Status Status of Hall IC1 Normal or Error

        Normal: Hall IC1 normal

        Error: Hall IC1 not normal

        		 -
        Hall IC2 Pulse Hall IC2 pulse output Lo or Hi Lo and Hi repeat during motor operation

        Lo: Hall IC2 output is low

        Hi: Hall IC2 output is high
        Hall IC2 Status Status of Hall IC2 Normal or Error

        Normal: Hall IC2 normal

        Error: Hall IC2 not normal

        		 -
        Ignition (MPX) Engine switch signal (LIN signal) ON or OFF

        ON: Engine switch on (IG)

        OFF: Engine switch off

        		 "OFF" is also displayed for this item when the engine switch is on (ACC).
        Hall IC1 Pulse(Shade) Hall IC1 pulse output (shade) Lo or Hi Lo and Hi repeat during motor operation

        Lo: Hall IC1 output is low

        Hi: Hall IC1 output is high
        Hall IC1 Status(Shade) Status of Hall IC1 (shade) Normal or Error

        Normal: Hall IC1 normal

        Error: Hall IC1 not normal

        		 -
        Hall IC2 Pulse(Shade) Hall IC2 pulse output (shade) Lo or Hi Lo and Hi repeat during motor operation

        Lo: Hall IC2 output is low

        Hi: Hall IC2 output is high
        Hall IC2 Status(Shade) Status of Hall IC2 (shade) Normal or Error

        Normal: Hall IC2 normal

        Error: Hall IC2 not normal

        		 -
        Door Key Close Operation Key-linked sliding roof close signal OFF or ON

        OFF: Driver door key cylinder not turned

        ON: Driver door key cylinder turned and held at the lock position

        		 -
        Door Key Open Operation Key-linked sliding roof open signal OFF or ON

        OFF: Driver door key cylinder not turned

        ON: Driver door key cylinder turned and held at the unlock position

        		 -
        Wireless Close Operation Wireless transmitter-linked sliding roof close signal OFF or ON

        OFF: Transmitter LOCK switch not pressed

        ON: Transmitter LOCK switch pressed and held

        		 -
        Wireless Open Operation Wireless transmitter-linked sliding roof open signal OFF or ON

        OFF: Transmitter UNLOCK switch not pressed

        ON: Transmitter UNLOCK switch pressed and held

        		 -
        Key Off Permission Key-off sliding roof operation permit signal OFF or ON

        OFF: Any status except "ON" status

        ON: Front doors are not opened within 45 seconds after engine switch turned off

        		 -
        Vent Switch TILT switch signal OFF or ON

        OFF: TILT switch not pressed

        ON: TILT switch pressed

        		 -
        Roof Open Switch OPEN switch signal OFF or ON

        OFF: Slide switch (OPEN) not pressed

        ON: Slide switch (OPEN) pressed

        		 -
        Roof Close Switch CLOSE switch signal OFF or ON

        OFF: Slide switch (CLOSE) not pressed

        ON: Slide switch (CLOSE) pressed

        		 -
        Shade Close Switch Front sunshade close switch signal OFF or ON

        OFF: Front roof sunshade switch (close) not pressed

        ON: Front roof sunshade switch (close) pressed

        		 -
        Shade Open Switch Front roof sunshade open switch signal OFF or ON

        OFF: Front roof sunshade switch (open) not pressed

        ON: Front roof sunshade switch (open) pressed

        		 -
        Current Roof Open Switch Stuck ON Sliding roof open switch stuck signal (Current) OFF or ON

        OFF: No sliding roof switch stuck signal (Current)

        ON: Sliding roof switch stuck signal (Current)

        		 -
        Current Roof Close Switch Stuck ON Sliding roof close switch stuck signal (Current) OFF or ON

        OFF: No sliding roof switch stuck signal (Current)

        ON: Sliding roof switch stuck signal (Current)

        		 -
        Current Shade Close Switch Stuck ON Roof sunshade close switch stuck signal (Current) OFF or ON

        OFF: No roof sunshade switch stuck signal (Current)

        ON: Roof sunshade switch stuck signal (Current)

        		 -
        Current Shade Open Switch Stuck ON Roof sunshade open switch stuck signal (Current) OFF or ON

        OFF: No roof sunshade switch stuck signal (Current)

        ON: Roof sunshade switch stuck signal (Current)

        		 -
        Past Roof Open Switch Stuck ON Sliding roof open switch stuck signal (Past) OFF or ON

        OFF: No sliding roof switch stuck signal (Past)

        ON: Sliding roof switch stuck signal (Past)

        		 -
        Past Roof Close Switch Stuck ON Sliding roof close switch stuck signal (Past) OFF or ON

        OFF: No sliding roof switch stuck signal (Past)

        ON: Sliding roof switch stuck signal (Past)

        		 -
        Past Shade Close Switch Stuck ON Roof sunshade close switch stuck signal (Past) OFF or ON

        OFF: No roof sunshade switch stuck signal (Past)

        ON: Roof sunshade switch stuck signal (Past)

        		 -
        Past Shade Open Switch Stuck ON Roof sunshade open switch stuck signal (Past) OFF or ON

        OFF: No roof sunshade switch stuck signal (Past)

        ON: Roof sunshade switch stuck signal (Past)

        		 -
        Current Vent Switch Stuck ON Sliding roof tilt switch stuck signal (Current) OFF or ON

        OFF: No sliding roof switch stuck signal (Current)

        ON: Sliding roof switch stuck signal (Current)

        		 -
        Past Vent Switch Stuck ON Sliding roof tilt switch stuck signal (Past) OFF or ON

        OFF: No sliding roof switch stuck signal (Past)

        ON: Sliding roof switch stuck signal (Past)

        		 -
        Suggestion Service Function Availability of suggestion function OFF or ON

        OFF: w/o Suggestion function

        ON: w/ Suggestion function

        		 -
        Number of Trouble Codes Number of trouble codes Min.: 0 to Max.: 255 Number of DTCs is displayed -

      2. Sliding roof drive gear assembly (rear roof sunshade ECU):


        Body Electrical > Rear Sliding Sunshade > Data List
        Tester Display Measurement Item Range Normal Condition Diagnostic Note
        Hall IC1 Status Status of Hall IC1 Normal or Error

        Normal: Hall IC1 normal

        Error: Hall IC1 not normal

        		 -
        Hall IC1 Pulse Hall IC1 pulse output Lo or Hi Lo and Hi repeat during motor operation

        Lo: Hall IC1 output is low

        Hi: Hall IC1 output is high
        Hall IC2 Status Status of Hall IC2 Normal or Error

        Normal: Hall IC2 normal

        Error: Hall IC2 not normal

        		 -
        Hall IC2 Pulse Hall IC2 pulse output Lo or Hi Lo and Hi repeat during motor operation

        Lo: Hall IC2 output is low

        Hi: Hall IC2 output is high
        Wireless Open Operation Wireless transmitter-linked roof sunshade open signal OFF or ON

        OFF: Transmitter UNLOCK switch not pressed

        ON: Transmitter UNLOCK switch pressed and held

        		 -
        Wireless Close Operation Wireless transmitter-linked roof sunshade close signal OFF or ON

        OFF: Transmitter LOCK switch not pressed

        ON: Transmitter LOCK switch pressed and held

        		 -
        Door Key Open Operation Key-linked roof sunshade open signal ON or OFF

        OFF: Driver door key cylinder not turned

        ON: Driver door key cylinder turned and held at the unlock position

        		 -
        Door Key Close Operation Key-linked roof sunshade close signal ON or OFF

        OFF: Driver door key cylinder not turned

        ON: Driver door key cylinder turned and held at the lock position

        		 -
        Ignition(MPX) Engine switch signal (LIN signal) ON or OFF

        ON: Engine switch on (IG)

        OFF: Engine switch off

        		 "OFF" is also displayed for this item when the engine switch is on (ACC).
        Key Off Permission Key-off roof sunshade operation permit signal ON or OFF

        OFF: Any status except "ON" status

        ON: Front doors are not opened within 45 seconds after engine switch turned off

        		 -
        Push Operating Switch Map light sub-assembly (rear roof sunshade switch) signal ON or OFF

        OFF: Map light sub-assembly (rear roof sunshade switch) not pressed

        ON: Map light sub-assembly (rear roof sunshade switch) pressed

        		 -
        Auto Open Operation Rear power seat switch (rear roof sunshade switch) OPEN operation signal ON or OFF

        OFF: Rear power seat switch (rear roof sunshade open switch) not automatically operated

        ON: Rear power seat switch (rear roof sunshade open switch) automatically operated

        		 -
        Auto Close Operation Rear power seat switch (rear roof sunshade switch) CLOSE operation signal ON or OFF

        OFF: Rear power seat switch (rear roof sunshade close switch) not automatically operated

        ON: Rear power seat switch (rear roof sunshade close switch) automatically operated

        		 -
        Stop Request Stop request signal sent from rear power seat switch (rear roof sunshade switch) ON or OFF

        OFF: Stop request signal from rear power seat switch (rear roof sunshade switch) not received

        ON: Stop request signal from rear power seat switch (rear roof sunshade switch) received

        		 -
        Push Switch Stuck ON(Current) Map light sub-assembly (rear roof sunshade switch) stuck signal (Current) ON or OFF

        OFF: No map light sub-assembly (rear roof sunshade switch) stuck signal (Current)

        ON: Map light sub-assembly (rear roof sunshade switch) stuck signal (Current)

        		 -
        Push Switch Stuck ON(Past) Map light sub-assembly (rear roof sunshade switch) stuck signal (Past) ON or OFF

        OFF: No map light sub-assembly (rear roof sunshade switch) stuck signal (Past)

        ON: Map light sub-assembly (rear roof sunshade switch) stuck signal (Past)

        		 -
        Number of Trouble Codes Number of trouble codes Min.: 0 to Max.: 255 Number of DTCs is displayed -

  2. ACTIVE TEST

    Tech Tips

    Using the GTS to perform Active Tests allows relays, VSVs, actuators and other items to be operated without removing any parts. This non-intrusive functional inspection can be very useful because intermittent operation may be discovered before parts or wiring is disturbed. Performing Active Tests early in troubleshooting is one way to save diagnostic time. Data List information can be displayed while performing Active Tests.


    1. Turn the engine switch off.

    2. Connect the GTS to the DLC3.

    3. Turn the engine switch on (IG).

    4. Turn the GTS on.

    5. Enter the following menus: Body Electrical / (desired system) / Active Test.

    6. According to the display on the GTS, perform the Active Test.


      1. Sliding roof drive gear assembly (front roof sunshade ECU):


        Body Electrical > Sliding Roof > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Front Sliding Sunshade Operate slide motor OFF / Open / Close -

      2. Sliding roof drive gear assembly (rear roof sunshade ECU):


        Body Electrical > Rear Sliding Sunshade > Active Test
        Tester Display Measurement Item Control Range Diagnostic Note
        Rear Sliding Sunshade Operate slide motor OFF / Open / Close -