SHIFT LEVER REMOVAL


  1. REMOVE SHIFT LEVER CAP


    1. B007RB1E01
      Text in Illustration
      *a Protective Tape

      Using a screwdriver, detach the 2 claws and remove the shift lever cap from the floor shift position indicator housing sub-assembly.

      Note

      Be careful not to damage the shift lever cap and floor shift position indicator housing sub-assembly.

      Tech Tips

      Tape the screwdriver tip before use.

  2. REMOVE SHIFT LEVER KNOB


    1. B007SAX

      Twist the shift lever knob in the direction indicated by the arrow and remove it.

  3. REMOVE FLOOR SHIFT POSITION INDICATOR HOUSING SUB-ASSEMBLY


    1. B007SU2

      Detach the 8 claws and remove the floor shift position indicator housing sub-assembly.

  4. REMOVE INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY NO. 1


    1. B007SZA

      Using a clip remover, remove the 2 clips

    2. Detach the 3 claws and remove the instrument panel under cover sub-assembly No. 1.

  5. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER


    1. B007R8L

      Using a clip remover, remove the 2 clips.

    2. Detach the 4 clips and remove the instrument panel finish lower.

    3. Disconnect each connector.

    4. B007TXW

      Push the positions indicated by the arrows in the illustration to disconnect the fuel lid lock control cable and bonnet (hood) control cable assembly from the instrument panel finish lower.

  6. REMOVE PARKING BRAKE HOLE COVER


    1. B007PNV

      Detach the 6 claws and remove the parking brake hole cover.

    2. Disconnect each connector.

  7. REMOVE INSTRUMENT PANEL FINISH PANEL LOWER CENTER


    1. B007VIUE01
      Text in Illustration
      *A for Manual Transmission
      *B for Automatic Transmission

      Detach the 8 claws and remove the instrument panel finish panel lower center.

  8. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Move the shift lever to N.

    2. B007QXC

      Disconnect the end of the transmission control cable assembly from the shift lock control unit assembly.

    3. B007VE9

      Using a screwdriver, pull out the stopper of the transmission control cable assembly.

      Tech Tips

      Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

    4. B007VR4

      Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable from the shift lock control unit assembly.

      Note

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

  9. REMOVE SHIFT LOCK CONTROL UNIT ASSEMBLY


    1. B007P7J

      Disconnect the 2 connectors and clamp from the shift lock control unit assembly.

    2. Remove the 4 bolts and shift lock control unit assembly.