WINDSHIELD OUTSIDE MOULDING INSTALLATION

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH side and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. INSTALL WINDSHIELD NO. 1 OUTSIDE MOULDING CLIP


    1. A01OCYG

      Using an air riveter or a hand riveter with a nose piece, install 5 new rivets.

      Tech Tips

      If the mandrel of the rivet does not come off on the first operation of the rivet gun, slide the rivet gun forward on the mandrel and operate it again.

      Note


      • Do not pry the rivet with the riveter, as this will cause damage to the riveter and mandrel.


      • A01OBVJC09
        *a Riveter
        *b Incorrect

        Confirm that the rivets are seated properly against the vehicle body.


      • Do not tilt the riveter when installing the rivet to the vehicle body.

      A01OBJ7C09
      *a Riveter
      *b Mandrel
      *c Incorrect
    2. A01OD9W

      Engage the 5 claws to install 5 new windshield No. 1 outside moulding clips as shown in the illustration.

  2. INSTALL WINDSHIELD OUTSIDE MOULDING


    1. A01OAXN

      Engage the 10 claws as shown in the illustration.

    2. A01OCCV

      Engage the 2 claws to install the windshield outside moulding.