ENGINE ASSEMBLY COMPONENTS
ILLUSTRATION
| *1 | FRONT FLOOR COVER CENTER LH | *2 | NO. 1 ENGINE COVER SUB-ASSEMBLY |
| *3 | NO. 1 ENGINE UNDER COVER ASSEMBLY | *4 | RADIATOR RESERVOIR ASSEMBLY |
| *5 | RADIATOR SUPPORT OPENING COVER | *6 | REAR ENGINE UNDER COVER LH |
| *7 | REAR ENGINE UNDER COVER RH | - | - |
 |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | AIR CLEANER CAP WITH AIR CLEANER HOSE | *2 | AIR CLEANER CASE SUB-ASSEMBLY |
| *3 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | *4 | BATTERY |
| *5 | BATTERY BRACKET REINFORCEMENT | *6 | BATTERY CARRIER ASSEMBLY |
| *7 | BATTERY CLAMP SUB-ASSEMBLY | *8 | BATTERY INSULATOR |
| *9 | BATTERY TRAY | *10 | ECM |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | w/ Air Cooled Transmission Oil Cooler | - | - |
| *1 | COMPRESSOR OUTLET ELBOW | *2 | DISCHARGE HOSE SUB-ASSEMBLY |
| *3 | HEATER HOSE | *4 | INTAKE AIR CONNECTOR |
| *5 | INTAKE AIR RESONATOR | *6 | NO. 1 AIR TUBE |
| *7 | NO. 1 RADIATOR HOSE | *8 | NO. 1 TRANSMISSION OIL COOLER HOSE ASSEMBLY |
| *9 | NO. 2 AIR CLEANER HOSE | *10 | NO. 2 INTERCOOLER COOLING WATER PIPE |
| *11 | NO. 2 RADIATOR HOSE | *12 | NO. 3 INTERCOOLER COOLING WATER PIPE |
| *13 | NO. 5 EXHAUST MANIFOLD HEAT INSULATOR | *14 | SUCTION HOSE SUB-ASSEMBLY |
| *15 | NO. 1 SUB-RADIATOR HOSE | *16 | NO. 4 SUB-RADIATOR HOSE |
| *17 | NO. 1 TURBO WATER HOSE | *18 | O-RING |
| *19 | GASKET | *20 | GROUND WIRE |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Compressor oil ND-OIL 11 or equivalent | - | - |
ILLUSTRATION
| *1 | FUEL TUBE SUB-ASSEMBLY | *2 | NO. 2 FUEL TUBE SUB-ASSEMBLY |
| *3 | FUEL VAPOR FEED HOSE ASSEMBLY | *4 | UNION TO CONNECTOR TUBE HOSE |
| *5 | ENGINE WIRE | *6 | ENGINE ROOM MAIN WIRE |
| *7 | GROUND WIRE | *8 | FUEL PIPE CLAMP |
| *9 | BATTERY CURRENT SENSOR CONNECTOR | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *1 | FRONT AXLE SHAFT NUT LH | *2 | FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH |
| *3 | FRONT SPEED SENSOR LH | *4 | FRONT STABILIZER LINK ASSEMBLY LH |
| *5 | TIE ROD END SUB-ASSEMBLY LH | *6 | FRONT STABILIZER BAR |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
 |
Do not apply lubricants to the threads parts | - | - |
ILLUSTRATION
| *A | for 2WD | *B | for AWD |
| *1 | DRIVE SHAFT BEARING BRACKET | *2 | FRONT DRIVE SHAFT ASSEMBLY LH |
| *3 | FRONT DRIVE SHAFT ASSEMBLY RH | *4 | FRONT DRIVE SHAFT HOLE SNAP RING LH |
| *5 | DRIVE SHAFT BEARING BRACKET HOLE SNAP RING | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
MP grease |  |
Toyota Genuine ATF WS |
| |
Do not apply lubricants to the threads parts | - | - |
ILLUSTRATION
| *A | for AWD | - | - |
| *1 | FRONT EXHAUST PIPE SUB-ASSEMBLY | *2 | FRONT NO. 2 EXHAUST PIPE SUB-ASSEMBLY |
| *3 | PROPELLER SHAFT WITH CENTER BEARING ASSEMBLY | *4 | TRANSMISSION CONTROL CABLE ASSEMBLY |
| *5 | GASKET | *6 | NO. 2 CENTER SUPPORT BEARING WASHER |
| *7 | COMPRESSION SPRING | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
Do not apply lubricants to the threads parts | - | - |
ILLUSTRATION
| *A | for LHD | - | - |
| *1 | COLUMN HOLE COVER SILENCER SHEET | *2 | ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
| *3 | ENGINE MOUNTING SPACER | *4 | FRONT SUSPENSION MEMBER REINFORCEMENT LH |
| *5 | FRONT SUSPENSION MEMBER REINFORCEMENT RH | *6 | NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
| *7 | ENGINE MOUNTING INSULATOR LH | *8 | FRONT ENGINE MOUNTING INSULATOR |
| *9 | FRONT CROSSMEMBER SUB-ASSEMBLY | *10 | FRONT SUSPENSION MEMBER REAR BRACE RH |
| *11 | FRONT SUSPENSION MEMBER REAR BRACE LH | *12 | RADIATOR RESERVOIR BRACKET |
| *13 | BRACKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for RHD | - | - |
| *1 | COLUMN HOLE COVER SILENCER SHEET | *2 | ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
| *3 | ENGINE MOUNTING SPACER | *4 | FRONT SUSPENSION MEMBER REINFORCEMENT LH |
| *5 | FRONT SUSPENSION MEMBER REINFORCEMENT RH | *6 | NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
| *7 | ENGINE MOUNTING INSULATOR LH | *8 | FRONT ENGINE MOUNTING INSULATOR |
| *9 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY | *10 | FRONT SUSPENSION MEMBER REAR BRACE RH |
| *11 | FRONT SUSPENSION MEMBER REAR BRACE LH | *12 | RADIATOR RESERVOIR BRACKET |
| *13 | BRACKET | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for 2WD | *B | for AWD |
| *C | for LHD | - | - |
| *1 | NO. 1 ENGINE HANGER | *2 | NO. 2 ENGINE HANGER |
| *3 | NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY | *4 | REAR ENGINE MOUNTING INSULATOR |
| *5 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY | *6 | CLAMP |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *A | for 2WD | *B | for AWD |
| *C | for RHD | - | - |
| *1 | NO. 1 ENGINE HANGER | *2 | NO. 2 ENGINE HANGER |
| *3 | NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY | *4 | REAR ENGINE MOUNTING INSULATOR |
| *5 | FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY | *6 | CLAMP |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *A | for 2WD | *B | for AWD |
| *1 | AUTOMATIC TRANSAXLE ASSEMBLY | *2 | DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
| *3 | DRIVE PLATE AND TORQUE CONVERTER CLUTCH SETTING BOLT | *4 | FLYWHEEL HOUSING UNDER COVER |
| *5 | STARTER ASSEMBLY | *6 | TRANSFER ASSEMBLY |
| *7 | TRANSMISSION OIL COOLER | *8 | REAR ENGINE MOUNTING BRACKET |
| *9 | FRONT DRIVE PLATE SPACER | *10 | REAR DRIVE PLATE SPACER |
| *11 | FRONT ENGINE MOUNTING BRACKET | *12 | REAR ENGINE MOUNTING BRACKET LH |
| *a | Black: x 1 Silver: x 5 |
- | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
| |
Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent | ★ | Precoated part |
| |
Do not apply lubricants to the threads parts | - | - |