IGNITION COIL AND SPARK PLUG REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil and spark plug removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Ignition coil assembly

  • Spark plug

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE RADIATOR COVER PLATE

    Click here

  3. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  4. REMOVE LOWER RADIATOR AIR DEFLECTOR

    Click here

  5. REMOVE RADIATOR SUPPORT TO CROSS MEMBER BRACE SUB-ASSEMBLY RH

    Click here

  6. DISCONNECT NO. 2 PCV HOSE

    Click here

  7. REMOVE AIR CLEANER WITH AIR CLEANER HOSE

    Click here

  8. REMOVE IGNITION COIL ASSEMBLY (for RHD)


    1. B005TAU

      for Bank 2:


      1. Remove the 2 nuts.

      2. Detach the 2 wire harness clamps.

      3. B005R8N

        Remove the bolt.

      4. B005U4M

        Remove the clip and No. 1 engine cover sub-assembly.

      5. Disconnect the 3 ignition coil assembly connectors.

      6. B005RI7

        Remove the 3 bolts and 3 ignition coil assemblies.

    2. B005S3A

      for Bank 1:


      1. Disconnect the 3 ignition coil assembly connectors.

      2. Remove the 3 bolts and 3 ignition coil assemblies.

  9. REMOVE IGNITION COIL ASSEMBLY (for LHD)


    1. B005XBV

      for Bank 2:


      1. Remove the 2 nuts.

      2. Detach the wire harness clamp.

      3. B005W8N

        Remove the bolt.

      4. B005U4M

        Remove the clip and No. 1 engine cover sub-assembly.

      5. Disconnect the 3 ignition coil assembly connectors.

      6. B005RI7

        Remove the 3 bolts and 3 ignition coil assemblies.

    2. B005S3A

      for Bank 1:


      1. Disconnect the 3 ignition coil assembly connectors.

      2. Remove the 3 bolts and 3 ignition coil assemblies.

  10. REMOVE SPARK PLUG

    Click here