ENGINE ASSEMBLY COMPONENTS
ILLUSTRATION
| *1 | NO. 1 ENGINE UNDER COVER | *2 | NO. 2 ENGINE UNDER COVER |
| *3 | NO. 3 ENGINE UNDER COVER | *4 | FRONT LOWER BUMPER ABSORBER |
| *5 | FRONT FENDER APRON SEAL LH | *6 | FRONT FENDER APRON SEAL RH |
| *7 | FRONT FLOOR COVER LH | *8 | FRONT WHEEL OPENING EXTENSION PAD LH |
| *9 | FRONT WHEEL OPENING EXTENSION PAD RH | - | - |
ILLUSTRATION
| *A | w/ Battery Insulator | *B | w/ NO. 3 Battery Clamp |
| *1 | INLET AIR CLEANER ASSEMBLY | *2 | AIR CLEANER CASE SUB-ASSEMBLY |
| *3 | AIR CLEANER BRACKET | *4 | AIR CLEANER CAP WITH AIR CLEANER HOSE |
| *5 | AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY | *6 | NO. 1 ENGINE COVER SUB-ASSEMBLY |
| *7 | ECM | *8 | BATTERY |
| *9 | BATTERY CARRIER SUB-ASSEMBLY | *10 | BATTERY BRACKET REINFORCEMENT |
| *11 | COOL AIR INTAKE DUCT SEAL | *12 | INTERCOOLER RESERVE TANK ASSEMBLY |
| *13 | BATTERY TRAY | *14 | BATTERY CLAMP SUB-ASSEMBLY |
| *15 | BATTERY CLAMP BOLT | *16 | POSITIVE BATTERY TERMINAL |
| *17 | NEGATIVE BATTERY TERMINAL | *18 | BATTERY INSULATOR |
| *19 | NO. 1 INTERCOOLER COOLING WATER HOSE | *20 | NO. 1 TURBO WATER HOSE |
| *21 | NO. 3 BATTERY CLAMP | - | - |
 |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) |  |
N*m (kgf*cm, ft.*lbf): Specified torque |
ILLUSTRATION
| *1 | INTAKE AIR CONNECTOR | *2 | INTAKE AIR RESONATOR |
| *3 | NO. 1 AIR TUBE | *4 | NO. 2 AIR CLEANER HOSE |
| *5 | NO. 5 EXHAUST MANIFOLD HEAT INSULATOR | *6 | OUTLET COMPRESSOR ELBOW |
| *7 | GASKET | *8 | NO. 3 INTERCOOLER COOLING WATER HOSE |
| *9 | NO. 3 VENTILATION HOSE | *10 | NO. 2 FUEL VAPOR FEED HOSE |
| *11 | FUEL TUBE SUB-ASSEMBLY | *12 | VACUUM SWITCHING VALVE HOSE ASSEMBLY |
| *13 | NO. 2 FUEL TUBE SUB-ASSEMBLY | *14 | NO. 5 INTERCOOLER COOLING WATER HOSE |
| *15 | NO. 2 INTERCOOLER COOLING WATER HOSE | *16 | NO. 6 INTERCOOLER COOLING WATER HOSE |
| *17 | NO. 4 INTERCOOLER COOLING WATER HOSE | *18 | NO. 2 INTERCOOLER COOLING WATER PIPE |
| *19 | NO. 3 INTERCOOLER COOLING WATER PIPE | *20 | ENGINE ROOM RELAY BLOCK ASSEMBLY |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *A | for LHD | *B | for RHD |
| *1 | DISCHARGE HOSE SUB-ASSEMBLY | *2 | SUCTION HOSE SUB-ASSEMBLY |
| *3 | TRANSMISSION CONTROL CABLE ASSEMBLY | *4 | UNION TO CHECK VALVE HOSE |
| *5 | HEATER HOSE | *6 | NO. 1 FUEL HOSE |
| *7 | FUEL VAPOR FEED HOSE ASSEMBLY | *8 | NO. 1 RADIATOR HOSE |
| *9 | NO. 2 RADIATOR HOSE | *10 | NO. 2 FUEL PIPE CLAMP |
| *11 | BATTERY STATE SENSOR ASSEMBLY | *12 | STEERING INTERMEDIATE SHAFT ASSEMBLY |
| *13 | O-RING | *14 | NO. 2 EARTH WIRE |
| *15 | UNION TO CONNECTOR TUBE HOSE | - | - |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | N*m (kgf*cm, ft.*lbf): Specified torque | |
| ● | Non-reusable part |  |
for HFC-134a (R134a): Compressor oil ND-OIL 8 or equivalent for HFO-1234yf (R1234yf): Compressor oil ND-OIL 12 or equivalent |
ILLUSTRATION
| *1 | FRONT EXHAUST PIPE ASSEMBLY | *2 | CENTER EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) |
| *3 | EXHAUST PIPE GASKET | *4 | COMPRESSION SPRING |
| *5 | EXHAUST PIPE SUPPORT | - | - |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | ● | Non-reusable part |
ILLUSTRATION
| *A | Type A | *B | Type B |
| *1 | ENGINE ASSEMBLY WITH TRANSAXLE | *2 | FRONT ENGINE MOUNTING INSULATOR |
| *3 | ENGINE MOUNTING INSULATOR LH | *4 | REAR ENGINE MOUNTING INSULATOR |
| *5 | ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH | *6 | ENGINE MOUNTING SPACER |
| *7 | FRONT FRAME ASSEMBLY | *8 | ENGINE WIRE |
| *9 | FRAME SIDE RAIL PLATE SUB-ASSEMBLY RH | *10 | FRAME SIDE RAIL PLATE SUB-ASSEMBLY LH |
| *11 | FRONT SUSPENSION MEMBER BRACKET SUB-ASSEMBLY RH | *12 | FRONT SUSPENSION MEMBER BRACKET SUB-ASSEMBLY LH |
| *13 | EARTH WIRE | *14 | BRAKE ACTUATOR WITH BRACKET |
| *15 | COOLER COMPRESSOR BRACKET | *16 | HOLE PLUG |
| *17 | VACUUM HOSE | - | - |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| * | For use with SST | - | - |
ILLUSTRATION
| *1 | FRONT STABILIZER BAR | *2 | STEERING LINK ASSEMBLY |
| *3 | FRONT NO. 1 STABILIZER BRACKET LH | *4 | FRONT NO. 1 STABILIZER BRACKET RH |
| *5 | FRONT NO. 2 STABILIZER BRACKET LH | *6 | FRONT NO. 2 STABILIZER BRACKET RH |
| |
N*m (kgf*cm, ft.*lbf): Specified torque | - | - |
ILLUSTRATION
| *A | for AWD | - | - |
| *1 | AUTOMATIC TRANSAXLE ASSEMBLY | *2 | TRANSMISSION OIL THERMOSTAT |
| *3 | STARTER ASSEMBLY | *4 | DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
| *5 | TRANSMISSION OIL COOLER | *6 | FLYWHEEL HOUSING UNDER COVER |
| *7 | FRONT DRIVE PLATE SPACER | *8 | REAR DRIVE PLATE SPACER |
| *9 | NO. 1 TRANSMISSION OIL COOLER HOSE | *10 | OUTLET OIL COOLER HOSE |
| *11 | TRANSMISSION OIL COOLER HOSE | *12 | DRIVE PLATE AND TORQUE CONVERTER ASSEMBLY SETTING BOLT |
| *13 | TRANSFER STIFFENER PLATE RH | *14 | NO. 1 BREATHER PLUG (ATM) |
| *a | BLACK COLOR: x 1 SILVER COLOR: x 5 |
- | - |
| |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf) | |
N*m (kgf*cm, ft.*lbf): Specified torque |
| |
Adhesive 1324 | ★ | Precoated part |