SPEED LIMITER SYSTEM

CAUTION / NOTICE / HINT

PROCEDURE

1. VEHICLE BROUGHT TO WORKSHOP

   Result

   Proceed to
   NEXT

   NEXT

2. INSPECT BATTERY VOLTAGE

   1. Measure the battery voltage with the ignition switch off.

      Standard Voltage

      11 to 14 V

      If the voltage is below 11 V, replace or recharge the battery before proceeding to the next step.

   Result

   Proceed to
   NEXT

   NEXT

3. CHECK COMMUNICATION FUNCTION OF CONTROLLER AREA NETWORK* (CAN)

   1. Using the GTS, check if the CAN communication system is functioning normally.

      Result

      Result	Proceed to
      CAN DTCs are not output (for 1KR-FE)	A
      CAN DTCs are not output (for 1PP)	B
      CAN DTCs are output	C

   B

   PROBLEM SYMPTOMS TABLEClick here

   C

   GO TO CAN COMMUNICATION SYSTEM

   Click hereClick here

   A

4. CHECK FOR DTC*

   Refer to DTC Check / Clear.

   Click here

   1. Check for DTCs and note any codes that are output.

   2. Clear the DTCs.

      Powertrain > Engine and ECT > Clear DTCs

   3. Recheck for DTCs. Try to reproduce the DTCs by duplicating the conditions indicated by the DTCs.

      Powertrain > Engine and ECT > Trouble Codes

      Result

      Result	Proceed to
      DTC does not reoccur	A
      DTC reoccurs	B

   B

   GO TO DTC CHART

   Click here

   A

5. PROBLEM SYMPTOMS TABLE

   Refer to Problem Symptoms Table.

   Click here

   Result

   Result	Proceed to
   Fault is not listed in Problem Symptoms Table	A
   Fault is listed in Problem Symptoms Table	B

   B

   REPAIR OR REPLACEClick here

   A

6. OVERALL ANALYSIS AND TROUBLESHOOTING*

   1. Road Test

      Click here

   2. Terminals of ECM

      Click here

   3. Data List / Active Test

      Click here

   Result

   Proceed to
   NEXT

   NEXT

7. REPAIR OR REPLACE

   Result

   Proceed to
   NEXT

   NEXT

8. CONFIRMATION TEST

   Result

   Proceed to
   NEXT

   NEXT

   END