FRONT DOOR LOCK REMOVAL

DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

CAUTION:

Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

Note:

After turning the engine switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work (Click here).
When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

REMOVE FRONT DOOR LOWER FRAME BRACKET GARNISH LH

REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

REMOVE FRONT ARMREST ASSEMBLY LH

REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR BASE PANEL

REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

REMOVE FRONT DOOR INNER GLASS WEATHERSTRIP LH

REMOVE FRONT NO. 1 SPEAKER ASSEMBLY

REMOVE FRONT DOOR SERVICE HOLE COVER LH

REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

REMOVE FRONT DOOR GLASS RUN LH

REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

REMOVE FRONT DOOR OUTSIDE HANDLE COVER WITH LOCK CYLINDER ASSEMBLY

REMOVE FRONT DOOR LOCK ASSEMBLY LH

*a	Slide

Using a T30 "TORX" wrench, remove the 3 screws.

Slide the front door lock assembly downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock assembly and cables as a unit.
Remove the front door lock open rod from the front door lock assembly.
Remove the door lock wiring harness seal from the front door lock assembly.

REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH