HEADLIGHT ASSEMBLY(for Sedan) REPAIR

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

  • If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair.

  • Ensure that the headlight assembly is not damaged.

PROCEDURE

  1. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER

    1. E290931

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E290932

      Install the upper headlight protector retainer with the 2 screws.

  2. INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER

    1. E290927

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E290928

      Install the upper No. 2 headlight protector retainer with the 2 screws.

  3. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER LH

    1. E290925

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the upper headlight protector retainer LH against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E290926

      Install the upper headlight protector retainer LH with the 2 screws.

  4. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER RH

    1. E290929

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the upper headlight protector retainer RH against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E290930

      Install the upper headlight protector retainer RH with the 2 screws.

  5. INSTALL LOWER HEADLIGHT PROTECTOR RETAINER

    1. E290933

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E290934

      Install the lower headlight protector retainer with the 2 screws.