HEADLIGHT ASSEMBLY(for Sedan) REPAIR

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

  • If the installation area of the headlight assembly is damaged, use a supply retainer for a low-cost repair.

  • Ensure that the headlight assembly is not damaged.

PROCEDURE

  1. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER

    1. E346410

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the upper headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E346411

      Install the upper headlight protector retainer with the 2 screws.

  2. INSTALL UPPER NO. 2 HEADLIGHT PROTECTOR RETAINER

    1. E346412

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the upper No. 2 headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E346413

      Install the upper No. 2 headlight protector retainer with the 2 screws.

  3. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER LH

    1. E346414

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the upper headlight protector retainer LH against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E346415

      Install the upper headlight protector retainer LH with the 2 screws.

  4. INSTALL UPPER HEADLIGHT PROTECTOR RETAINER RH

    1. E346416

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the upper headlight protector retainer RH against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E346417

      Install the upper headlight protector retainer RH with the 2 screws.

  5. INSTALL LOWER HEADLIGHT PROTECTOR RETAINER

    1. E346418

      Cut off the part shaded in the illustration and sand smooth with sandpaper.

      Note:

      After cutting off the part, place the lower headlight protector retainer against the bosses and gradually file away the old bracket if it interferes with the installation of a supply retainer.

    2. E346419

      Install the lower headlight protector retainer with the 2 screws.