ENGINE SWITCH INSPECTION

PROCEDURE

  1. INSPECT ENGINE SWITCH

    1. Measure the resistance according to the value(s) in the table below.

      A256118C06

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      5 (SS1) - 6 (AGND)

      Not pushed

      10 kΩ or higher

      1 (SS2) - 6 (AGND)

      5 (SS1) - 6 (AGND)

      Pushed

      Below 1 Ω

      1 (SS2) - 6 (AGND)

      If the result is not as specified, replace the engine switch.

    2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch.

      Note:

      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator will not illuminate.

      • If the voltage is too low, the indicator will not illuminate.

      Standard

      Measurement Condition

      Specified Condition

      Battery positive (+) → Terminal 9 (SWIL)

      Battery negative (-) → Terminal 6 (AGND)

      Illuminates
      A256118C07

      *a

      Indicator Light

      -

      -

      If the result is not as specified, replace the engine switch.