UNDER BODY TWO-DIMENSIONAL DISTANCE

Tip:

Point J, j on the vehicle are asymmetrical.
Length measurements are indicated at the points where the arrows extending from the zero point intersect the lines that extend towards the outside of the illustration from each point.
In cases in which only one dimension is given, left and right are symmetrical.
For symbols, capital letters indicate right side of vehicle, small letters indicate left side of vehicle (seen from rear).

Table 1. Measuring Point Name
Symbol	Name	Hole Diameter mm (in.)
A, a	Front Bumper Reinforcement Installation Nut	M10 (0.39)
B, b	Front Crossmember Installation Nut	M6 (0.24)
C, c	Front Side Member Standard Hole	φ18 (0.71)
D, d	Front Spring Support Plate Standard Hole	φ10 (0.39)
E, e	Front Suspension Crossmember Installation Nut	M12 (0.47)
F, f	Front Suspension Crossmember Installation Nut	M12 (0.47)
G, g	Front Frame Installation Nut	M10 (0.39)
H, h	Torque Front Box Standard Hole	φ25 (0.98)
J, j	Front Side Member Brace Standard Hole	φ10 (0.39)
K, k	Front Side Inner Rear Member Standard Hole	φ18 (0.71)
L, l	Front Floor Under Reinforcement Standard Hole	φ10 (0.39)
M, m	Rear Floor Side Member Standard Hole	φ18 (0.71)
N, n	Trailing Arm Installation Hole	φ14 (0.55)
O, o	Rear Floor Side Member Standard Hole	φ18 (0.71)
P, p	Rear Floor Side Member Standard Hole	φ13 (0.52)
Q, q	Rear Shock Absorber Installation Hole	φ18 (0.71)
R, r	Rear Floor Side Member Standard Hole	φ18 (0.71)

Table 2. Wheel Base
Wheel Base	2340 mm (92.13 in.)

K115820C01

K115821C01