TRANSFER OIL ON-VEHICLE INSPECTION

PROCEDURE

  1. CHECK TRANSFER OIL

    1. C217371

      Remove the filler plug and gasket.

    2. C261355C01

      *a

      0 to 5 mm

      Check that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.

      If the result is not as specified, add transfer oil.

      Note:

      Too much or too little oil will lead to transfer problems.

    3. When the oil level is too low, check for oil leaks.

    4. Install a new gasket to the filler plug and then tighten the plug.

      37 N*m

      377 kgf*cm

      27 ft.*lbf

  2. ADD TRANSFER OIL

    1. Remove the filler plug and gasket.

    2. Add oil so that the oil level is between 0 to 5.0 mm (0 to 0.196 in.) from the bottom lip of the filler plug hole.

      Note:
      • Add oil slowly.

      • Add oil a little at a time, waiting several minutes between each addition of oil.

      Tip:
      • Oil type

        Toyota Genuine Transfer Gear oil LF or equivalent

        Viscosity

        SAE 75W

        Capacity

        1.4 liters (1.5 US qts, 1.2 lmp.qts)

    3. Wait approximately 5 minutes and check that the oil level has not changed.

    4. Install a new gasket to the filler plug and then tighten the plug.

      37 N*m

      377 kgf*cm

      27 ft.*lbf