REAR DOOR LOCK(for Hatchback, Wagon) REMOVAL

CAUTION / NOTICE / HINT

Tip:
  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. PRECAUTION (w/ Power Window)

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL (w/ Power Window)

  3. REMOVE REAR ARMREST ASSEMBLY (w/o Power Window)

  4. REMOVE REAR ARMREST ASSEMBLY (w/ Power Window)

  5. REMOVE REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

  6. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

  7. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

  8. REMOVE REAR DOOR SERVICE HOLE COVER

  9. DISCONNECT REAR DOOR WEATHERSTRIP

  10. DISCONNECT REAR DOOR GLASS RUN

  11. REMOVE REAR DOOR REAR WINDOW GUIDE WITH REAR DOOR REAR GUIDE SEAL

  12. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

  13. REMOVE REAR DOOR GLASS RUN

  14. REMOVE REAR DOOR LOCK ASSEMBLY

    1. B334011C01

      *a

      Release Plate

      Disconnect the connector.

    2. Using a T30 "TORX" socket wrench, remove the 3 screws.

    3. Move the rear door lock assembly downward and pull the release plate out of the rear door outside handle frame.

    4. When reusing the rear door lock assembly:

      1. B334012

        Remove the door lock wiring harness seal from the rear door lock assembly.

  15. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/o Double Locking System)

  16. REMOVE REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY (w/ Double Locking System)

  17. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/o Double Locking System)

  18. REMOVE REAR DOOR INSIDE LOCKING CABLE ASSEMBLY (w/ Double Locking System)