КОРПУС ДРОССЕЛЬНОЙ ЗАСЛОНКИ ДИЗЕЛЬНОГО ДВИГАТЕЛЯ УСТАНОВКА


  1. INSTALL VENTURI ASSEMBLY


    1. Place a new gasket and the venturi on the intake manifold.

    2. A01E2GDE02

      Connect the throttle control motor connector.

    3. A01DWS5E02

      Connect the throttle open switch connector.

  2. INSTALL INTAKE FLANGE


    1. A01E0RK

      Install a new gasket and the intake flange with the 3 nuts.

      Torque:
      12 N*m  { 122 kgf*cm, 9 ft.*lbf }

    2. Connect the ventilation hose with the clamp.

    3. A01E2KC

      Connect the manifold absolute pressure sensor connector.

    4. A01DVEZ

      Install the clamp of the heater hose with the bolt.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

  3. INSTALL INTAKE PIPE ASSEMBLY


    1. A01DZM6

      Connect the intake pipe to the intake flange with the clamp.

    2. Fix the intake pipe in place with the 2 bolts and clamp.

      Torque:
      18 N*m  { 184 kgf*cm, 13 ft.*lbf, for bolt }
      6.0 N*m  { 61 kgf*cm, 53 in.*lbf, for clamp }

  4. CONNECT NO. 1 AIR CLEANER HOSE


    1. Connect the air cleaner hose to the air cleaner and intake pipe with the 2 clamps.

    2. Fix the intake pipe in place with the 2 clamps.

      Torque:
      5.0 N*m  { 51 kgf*cm, 44 in.*lbf }

    3. Connect the IAT sensor connector.

    4. Attach the clamp of the IAT sensor harness.

  5. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

  6. PERFORM INITIALIZATION


    1. Perform initialization Click here.

      Note

      Certain systems need to be initialized after disconnecting and reconnecting the cable from the negative (-) battery terminal.