STEREO COMPONENT AMPLIFIER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during stereo component amplifier assembly removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedures Effect/Inoperative Function When Necessary Procedures are not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane Departure Alert System (w/ Steering Control)

Click here

Pre-collision System
Memorize steering angle neutral point Parking Assist Monitor System

Click here

Panoramic View Monitor System

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

Click here

B0084SX

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY LH

    Click here

  2. REMOVE AUDIO AMPLIFIER COVER


    1. B0083LO

      Remove the 3 clips and audio amplifier cover.

  3. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY WITH BRACKET


    1. B0085Y3

      Disconnect each connector.

    2. Disengage the clamp.

    3. B00844N

      Turn back the front floor carpet assembly and front floor mat as shown in the illustration.

    4. B0087JB

      Remove the bolt.

    5. Disengage the 2 guides and remove the stereo component amplifier assembly with bracket as shown in the illustration.

      B0089ISC01
      B00847Z Remove in this Direction (1) B008776 Remove in this Direction (2)

  4. REMOVE NO. 1 AMPLIFIER BRACKET


    1. B00861Y

      Remove the 2 screws and No. 1 amplifier bracket.

  5. REMOVE NO. 2 AMPLIFIER BRACKET


    1. B0087EV

      Remove the 2 screws and No. 2 amplifier bracket.

  6. REMOVE STEREO COMPONENT AMPLIFIER ASSEMBLY