VEHICLE STABILITY CONTROL SYSTEM Slip Indicator Light Remains ON

DESCRIPTION

The skid control ECU (brake actuator assembly) is connected to the combination meter assembly via CAN communication.

The slip indicator light blinks during VSC and/or TRC operation.

If a malfunction is detected, the slip indicator light comes on to warn the driver Click here.

WIRING DIAGRAM

INSPECTION PROCEDURE

PROCEDURE

1. CHECK CAN COMMUNICATION LINE Click here

   
   

   B

   CHECK CAN COMMUNICATION SYSTEM Click here

   A

2. CHECK BRAKE ACTUATOR ASSEMBLY CONNECTOR IS SECURELY CONNECTED

   
   

   NG

   CONNECT CONNECTOR TO BRAKE ACTUATOR ASSEMBLY CORRECTLY

   OK

3. INSPECT BATTERY Click here

   
   

   NG

   CHECK OR REPLACE CHARGING SYSTEM OR BATTERY

   OK

4. CHECK TERMINAL VOLTAGE (IG1 TERMINAL) Click here

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR (IG1 CIRCUIT)

   OK

5. CHECK HARNESS AND CONNECTOR (GND1 TERMINAL) Click here

   
   

   NG

   REPAIR OR REPLACE HARNESS OR CONNECTOR (GND1 CIRCUIT)

   OK

6. READ VALUE USING GTS (SLIP INDICATOR LIGHT)

   
   

   1. Reconnect the B92 skid control ECU (brake actuator assembly) connector.

   2. Connect the GTS to the DLC3.

   3. Turn the ignition switch to ON.

   4. Turn the GTS on.

   5. Enter the following menus: Chassis / ABS/VSC/TRC / Data List.

   6. According to the display on the GTS, read the Data List.

      ABS/VSC/TRC

      Tester Display	Measurement Item/Range	Normal Condition	Diagnostic Note
      Slip Indicator Light	Slip indicator light / ON or OFF	ON: Indicator light on OFF: Indicator light off	-

   7. Check the GTS display condition of the slip indicator light.

      Result
      Result Proceed to Display of the Data List remains OFF A Display of the Data List remains ON B

   
   

   B

   REPLACE BRAKE ACTUATOR ASSEMBLY Click here

   A

   INSPECT METER / GAUGE SYSTEM Click here