REAR CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE

  1. REMOVE HYBRID VEHICLE TRANSAXLE ASSEMBLY

    Click here

  2. REMOVE TRANSMISSION INPUT DAMPER ASSEMBLY

    1. A311150N02

      Using SST, hold the crankshaft pulley assembly.

      09213-54015

      09330-00021

      Tip:

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. A260502

      Remove the 6 bolts and transmission input damper assembly.

  3. REMOVE FLYWHEEL SUB-ASSEMBLY

    1. A311150N01

      Using SST, hold the crankshaft pulley assembly.

      09213-54015

      09330-00021

      Tip:

      Part number of installation bolt for SST (crankshaft pulley holding tool): 91551-80650 (quantity: 2)

    2. A259955

      Remove the 8 bolts, then remove the flywheel sub-assembly.

  4. REMOVE REAR ENGINE OIL SEAL

    1. A195809C06

      *a

      Cut Position

      *b

      Protective Tape

      Using a knife, cut off the lip of the rear engine oil seal.

    2. Using a screwdriver, pry out the rear engine oil seal.

      Note:

      Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.

      Tip:

      Tape the screwdriver tip before use.