SFI SYSTEM, Diagnostic DTC:P2119

DTC Code DTC Name
P2119 Throttle Actuator Control Throttle Body Range / Performance

DESCRIPTION

Refer to DTC P2101.

Click hereClick here

DTC No.

Detection Item

DTC Detection Condition

Trouble Area

MIL

Memory

P2119

Throttle Actuator Control Throttle Body Range / Performance

Both of the following conditions are met (1 trip detection logic):

  • DTC P2112 is not output

  • The throttle does not close when current is not applied to the throttle motor

Throttle body with motor assembly

Comes on

DTC stored

CONFIRMATION DRIVING PATTERN

DTC P2119 is detected when the ignition switch is ON.

CAUTION / NOTICE / HINT

Note:

After replacing the throttle body with motor assembly, perform electronic throttle learning and idle learning.

Click here

Tip:

Read freeze frame data using the GTS. Freeze frame data records the engine condition when malfunctions are detected. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air fuel ratio was lean or rich, and other data from the time the malfunction occurred.

PROCEDURE

  1. INSPECT THROTTLE BODY WITH MOTOR ASSEMBLY (VISUALLY CHECK THROTTLE VALVE)

    1. Remove the throttle body with motor assembly.

      Click hereClick here

    2. Check for contamination between the throttle valve and the housing, and check that the throttle valve moves smoothly.

      OK

      No contamination between the throttle valve and the housing, and the throttle valve moves smoothly.

    3. Reinstall the throttle body with motor assembly.

      Click hereClick here

    4. Perform electronic throttle learning and idle learning.

      Click here

    Result

    Proceed to

    OK

    NG
    NG

    CLEAN THROTTLE BODY WITH MOTOR ASSEMBLY

    OK

  2. REPLACE THROTTLE BODY WITH MOTOR ASSEMBLY

    1. Replace the throttle body with motor assembly.

      Click hereClick here

    2. Perform electronic throttle learning and idle learning.

      Click here

    Result

    Proceed to

    NEXT
    NEXT

  3. CHECK WHETHER DTC OUTPUT RECURS (DTC P2119)

    1. Connect the GTS to the DLC3.

    2. Turn the ignition switch to ON.

    3. Turn the GTS on.

    4. Clear the DTCs.

      Powertrain > Engine and ECT > Clear DTCs

    5. Turn the ignition switch off and wait for at least 30 seconds.

    6. Turn the ignition switch to ON.

    7. Turn the GTS on.

    8. Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.

    9. Read the DTCs.

      Powertrain > Engine and ECT > Trouble Codes

      OK

      DTCs are not output.

    Result

    Proceed to

    NEXT
    NEXT

    END