METER / GAUGE SYSTEM
| DTC Code | DTC Name |
|---|---|
| HOW TO PROCEED WITH TROUBLESHOOTING |
CAUTION / NOTICE / HINT
Use these procedures to troubleshoot the meter/gauge system.
*: Use the GTS.
PROCEDURE
VEHICLE BROUGHT TO WORKSHOP
Result
Proceed to
NEXT
INSPECT BATTERY VOLTAGE
Standard voltage
11 to 14 V
If the voltage is below 11 V, recharge or replace the battery before proceeding.
Result
Proceed to
NEXT
CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM*
Use the GTS to check if the CAN communication system is functioning normally.
for LHD:Click here
for RHD:Click here
Result
Proceed to
CAN communication system DTC is not output
CAN communication system DTC is output (for LHD)
CAN communication system DTC is output (for RHD)
CAN communication system DTC is output (for LHD) GO TO CAN COMMUNICATION SYSTEM
for LHD:Click here
for RHD:Click here
CAN communication system DTC is output (for RHD) GO TO CAN COMMUNICATION SYSTEM
for LHD:Click here
for RHD:Click here
CHECK FOR DTC*
Check for DTCs.
Body Electrical > Combination Meter > Trouble Codes
Clear the DTCs.
Body Electrical > Combination Meter > Clear DTCs
Recheck for DTCs.
Body Electrical > Combination Meter > Trouble Codes
Result
Proceed to
DTC is not output
DTC is output
PROBLEM SYMPTOMS TABLE
Refer to Problem Symptoms Table.
Result
Proceed to
Fault is not listed in problem symptoms table
Fault is listed in problem symptoms table
Fault is listed in problem symptoms table ADJUST, REPAIR OR REPLACE IN ACCORDANCE WITH PROBLEM SYMPTOMS TABLE
OVERALL ANALYSIS AND TROUBLESHOOTING*
Terminals of ECU
Data List / Active Test
Operation Check
Result
Proceed to
NEXT
REPAIR OR REPLACE
Result
Proceed to
NEXT
CONFIRMATION TEST
Result
Proceed to
NEXT
NEXT END