4WD CONTROL ECU INSTALLATION

PROCEDURE


  1. PRECAUTION

    Note

    When 4WD ECU assembly is replaced with a known good one from another vehicle, it is necessary to perform calibration.

    Click here

  2. INSTALL 4WD ECU ASSEMBLY


    1. B007ZGMC01
      *a Stopper

      Install the 4WD ECU assembly with the bolt.

      Torque:
      8.5 N*m  { 87 kgf*cm, 75 in.*lbf }

    2. Connect the 4WD ECU assembly connector.

  3. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

    Click here

  4. INSTALL COWL SIDE TRIM BOARD RH

    Click here

  5. INSTALL FRONT DOOR SCUFF PLATE RH

    Click here

  6. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here