FRONT DOOR LOCK REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work Click here.

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected Click here.

  3. REMOVE FRONT DOOR INSIDE HANDLE BEZEL PLUG LH

    Click here

  4. REMOVE ASSIST GRIP COVER LH

    Click here

  5. REMOVE POWER WINDOW REGULATOR MASTER SWITCH ASSEMBLY WITH FRONT DOOR ARMREST BASE PANEL

    Click here

  6. REMOVE FRONT DOOR TRIM BOARD SUB-ASSEMBLY LH

    Click here

  7. REMOVE FRONT INNER DOOR GLASS WEATHERSTRIP LH

    Click here

  8. REMOVE FRONT DOOR SERVICE HOLE COVER LH

    Click here

  9. REMOVE FRONT DOOR GLASS SUB-ASSEMBLY LH

    Click here

  10. REMOVE FRONT DOOR GLASS RUN LH

    Click here

  11. REMOVE FRONT DOOR REAR LOWER FRAME SUB-ASSEMBLY LH

    Click here

  12. REMOVE FRONT DOOR OUTSIDE HANDLE COVER LH

    Click here

  13. REMOVE FRONT DOOR LOCK ASSEMBLY LH


    1. A004OHNE02
      *1 w/o Double Locking System:
      *2 w/ Double Locking System:

      Using a T30 "TORX" wrench, remove the 3 screws.

    2. Slide the front door lock assembly downward, pull out the front door lock open rod from the outside handle frame, and remove the front door lock assembly and cables as a unit.

    3. Remove the front door lock open rod from the front door lock assembly.

    4. Remove the door lock wiring harness seal from the front door lock assembly.

  14. REMOVE FRONT DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY LH

    Click here

  15. REMOVE FRONT DOOR INSIDE LOCKING CABLE ASSEMBLY LH

    Click here