GENERATOR INSTALLATION

PROCEDURE

1. INSTALL GENERATOR ASSEMBLY

   1. Install the wire harness clamp bracket to the generator assembly with the bolt.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

   2. Using an E8 "TORX" socket wrench, temporarily install the generator assembly with the stud bolt.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

   3. Install the generator assembly with the bolt and 2 nuts.

      25 N*m

      255 kgf*cm

      18 ft.*lbf

   4. Engage the wire harness clamp.

   5. Connect the generator assembly connector.

   6. Connect the wire harness to terminal B with the nut.

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

   7. Install the terminal cap.

2. INSTALL V-RIBBED BELT

   Click here

3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click hereClick hereClick hereClick here