REAR SEAT OUTER BELT ASSEMBLY(for Sedan) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE REAR BENCH TYPE SEAT CUSHION ASSEMBLY

    Click here

  2. REMOVE REAR SIDE SEATBACK ASSEMBLY LH

    A004P9F

    1. Remove the bolt and disconnect the outer belt anchor.

    2. A004Q46

      Using a screwdriver, detach the claw to open the cap of the rear seat shoulder belt guide.

    3. Remove the seat belt from the belt guide.

    4. A004QF9

      Remove the bolt and side seatback LH.

  3. REMOVE REAR SIDE SEATBACK ASSEMBLY RH

    Tech Tips

    Use the same procedure described for the LH side.

  4. DISCONNECT REAR CENTER SEAT OUTER BELT ASSEMBLY

    Click here

  5. REMOVE INNER ROOF SIDE GARNISH LH

    Click here

  6. REMOVE INNER ROOF SIDE GARNISH RH

    Click here

  7. REMOVE REAR SEAT SHOULDER BELT HOLE COVER

    A004RT2

    1. Using a moulding remover, detach the 4 claws and remove the belt hole cover.

      Tech Tips

      Use the same procedure to remove all the belt hole covers.

  8. REMOVE PACKAGE TRAY TRIM PANEL ASSEMBLY

    A004RUU

    1. Disconnect the connector.

    2. Remove the 4 clips.

    3. Detach the 2 clips and raise the front portion of the package tray trim panel assembly.

    4. Pass the 3 rear seat belt floor anchors through the package tray trim panel assembly.

    5. Detach the 5 claws and remove the package tray trim panel assembly.

  9. REMOVE NO. 1 ROOM PARTITION BOARD

    A004R6L

    1. Remove the 4 clips.

    2. Using a moulding remover, detach the 4 clips and remove the partition board.

  10. REMOVE NO. 1 PACKAGE TRAY TRIM PAD

    Tech Tips

    Perform the following procedure if replacing the No. 1 package tray trim pad.


    1. Remove the package tray trim pad.

  11. REMOVE NO. 2 PACKAGE TRAY TRIM PAD

    Tech Tips

    Perform the following procedure if replacing the No. 2 package tray trim pad.


    1. Remove the package tray trim pad.

  12. REMOVE NO. 3 PACKAGE TRAY TRIM PAD

    Tech Tips

    Perform the following procedure if replacing the No. 3 package tray trim pad.


    1. Remove the package tray trim pad.

  13. REMOVE REAR SEAT 3 POINT TYPE BELT ASSEMBLY LH

    A004RNU

    1. Remove the nut and seat belt.

  14. REMOVE OUTER BELT ANCHOR BRACKET SUB-ASSEMBLY LH

    A004Q9V

    1. Remove the bolt and anchor bracket.