ECM REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here

  3. REMOVE BATTERY (for RHD)

    Click hereClick here

  4. REMOVE BATTERY CLAMP SUB-ASSEMBLY (for RHD)

    Click hereClick here

  5. REMOVE ECM

    1. A321697C01

      *A

      for LHD

      *B

      for RHD

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

      Note:

      After disconnecting the ECM connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the ECM connectors.

    2. Disengage the wire harness clamp. (for LHD)

    3. A321699

      Remove the 2 bolts and ECM.

      Note:

      If the ECM has been struck or dropped, replace it.

  6. REMOVE NO. 1 ECM BRACKET

    1. A321700

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

  7. REMOVE NO. 2 ECM BRACKET

    1. A321701

      Remove the 2 screws and No. 2 ECM bracket from the ECM.