REAR BUMPER(w/ Rear No. 2 Seat) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear bumper removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Rear bumper assembly (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

  • Intelligent clearance sonar system

  • LEXUS Parking Assist-sensor System

Click here

PROCEDURE


  1. REMOVE REAR LIGHT COVER LH

    Click here

  2. REMOVE REAR LIGHT COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  3. DISCONNECT QUARTER OUTSIDE MOULDING SUB-ASSEMBLY LH


    1. B007YZLC01
      B007ZL6 Protective Tape

      Apply protective tape around the quarter outside moulding sub-assembly LH and rear bumper assembly as shown in the illustration.

    2. B007YVS

      Using a 4 mm hexagon socket wrench, remove the screw.

    3. Remove the clip.

    4. B007YFMC01
      B007Z37 Remove in this Direction (1)
      B007YXL Remove in this Direction (2)

      Pull back the edge of the rear wheel house liner LH and disengage the 4 claws by pushing the area indicated by the arrow in the illustration with a finger.

      Note


      • Do not apply excessive force when pulling back the rear wheel house liner LH.

      • To avoid damaging the claws, do not forcibly pull the quarter outside moulding sub-assembly LH.

    5. Disengage the clip to disconnect the quarter outside moulding sub-assembly LH from the rear bumper assembly.

  4. DISCONNECT QUARTER OUTSIDE MOULDING SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.

  5. REMOVE LUGGAGE COMPARTMENT SIDE COVER LH (w/o Spare Tire)


    1. B007Z68C01
      *1 Luggage Compartment Side Cover Protector Clip
      B007Z37 Remove in this Direction

      Remove the 6 clips.

    2. Disengage the 2 luggage compartment side cover protector clips as shown in the illustration.

    3. Remove the 3 bolts and luggage compartment side cover LH.

  6. REMOVE REAR BUMPER ASSEMBLY


    1. B007ZGW

      Remove the 4 screws.

    2. B007YRI

      Remove the 8 clips.

    3. B007YEQC01
      B007Z37 Remove in this Direction

      Disengage the 6 claws as shown in the illustration.

      Tech Tips

      Use the same procedure for the RH side and LH side.

    4. B007ZZ9C01
      B007Z37 Remove in this Direction

      Disengage the 2 claws as shown in the illustration to remove the rear bumper assembly.

    5. w/ LEXUS Parking Assist-sensor System:


      1. Disconnect the connector.