REAR DOOR LOCK(for Sedan) INSTALLATION

CAUTION / NOTICE / HINT

PROCEDURE

1. INSTALL REAR DOOR INSIDE LOCKING CABLE ASSEMBLY

   Click here

2. INSTALL REAR DOOR LOCK REMOTE CONTROL CABLE ASSEMBLY

   Click here

3. INSTALL REAR DOOR LOCK WITH MOTOR ASSEMBLY

   Note:

   • When reusing a removed rear door lock with motor assembly, replace the door lock wiring harness seal with a new one.

   • Do not allow grease or dust to adhere to the door lock wiring harness seal installation surface.

   • Reusing a door lock wiring harness seal or using a damaged door lock wiring harness seal may cause water ingress. This may result in a malfunction of the rear door lock with motor assembly.

   1. Apply MP grease to the sliding parts of the rear door lock with motor assembly.

   2. When reusing the rear door lock with motor assembly:

      1. 

         Install a new door lock wiring harness seal to the rear door lock with motor assembly.

   3. 

      *a	Release Plate

      Connect the rear door lock with motor assembly to the release plate of the rear door outside handle frame, and set it to the rear door panel.

      Tip:

      Make sure that the release plate of the rear door outside handle frame is securely connected to the rear door lock with motor assembly.

   4. Using a T30 "TORX" socket wrench, install the rear door lock with motor assembly with the 3 screws.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

   5. Connect the connector.

4. INSTALL REAR DOOR GLASS SUB-ASSEMBLY

   Click here

5. INSTALL REAR DOOR QUARTER WINDOW GLASS

   Click here

6. INSTALL REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

   Click here

7. INSTALL NO. 1 REAR DOOR VENT SEAL

   Click here

8. INSTALL REAR DOOR GLASS RUN

   Click here

9. CONNECT REAR DOOR WEATHERSTRIP

   Click here

10. INSTALL REAR DOOR SERVICE HOLE COVER

    Click here

11. INSTALL REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

12. INSTALL REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

13. INSTALL REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL (w/ Power Window)

    Click here

14. INSTALL REAR DOOR ARMREST UPPER BASE PANEL (w/o Power Window)

    Click here

15. INSTALL REAR DOOR WINDOW REGULATOR HANDLE ASSEMBLY (w/o Power Window)

    Click here

16. INSTALL REAR ARMREST ASSEMBLY

    Click here

17. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

18. INSPECT POWER WINDOW OPERATION

    Click here