RAIN SENSOR INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE

  1. INSTALL RAIN SENSOR

    Note:

    If there are problems with the silicon mixture, replace the rain sensor.

    1. Clean the surface of the windshield glass that contacts the rain sensor.

    2. When replacing the rain sensor with a new one:

      Remove the protective cover on the rain sensor.

      Note:

      Do not touch the silicon mixture directly with a finger.

    3. E184786

      Connect the connector.

      Note:

      Do not touch the silicon mixture directly with a finger.

    4. E184788

      Attach the 2 claws to install the rain sensor as shown in the illustration.

      Note:

      Make sure that there are no air bubbles between the silicon mixture and windshield glass.

  2. INSTALL NO. 2 RAIN SENSOR COVER

    1. E184789

      Using a screwdriver, attach the 2 claws to install the No. 2 rain sensor cover.

  3. INSTALL NO. 1 RAIN SENSOR COVER

    1. E186137

      Attach the 2 claws to connect the No. 1 rain sensor cover.

      Note:

      Be careful not to damage the No. 1 rain sensor cover.

    2. E184785

      Attach the 3 claws to install the No. 1 rain sensor cover.