FRONT DISC BRAKE PAD(except 6-Pot Caliper) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides, except where indicated.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEEL

    Click here

  2. REMOVE FRONT DISC BRAKE PAD

    CAUTION:

    Be careful not to get pinched by the disc brake cylinder assembly or other parts when removing the front disc brake pads.

    Note

    Be sure to inspect the front disc when replacing the front disc brake pads with new ones.

    Click here


    1. for RH side:


      1. B006F4E

        Disconnect the front pad wear indicator wire connector assembly RH from the front skid control sensor wire.

      2. B006BU5N01

        Disconnect the clamp (A) from the front disc brake dust cover RH.

      3. Disconnect the bleeder plug cap (B) from the disc brake cylinder assembly RH.

    2. B006D1SN02

      While pressing the area (A), push the hole pin (B) toward the disk brake cylinder assembly LH, and remove the pin hold clip.

    3. B0069MZN02

      While pressing the area (A), remove the 2 hole pins (B) and No. 1 anti-rattle spring.

    4. Remove the anti-squeal spring.

    5. B006EM0

      Remove the 2 front disc brake pads from the disk brake cylinder assembly LH.

    6. for RH side:


      1. B006DDN

        Detach the pad wear indicator retainer and remove the pad wear indicator wire assembly RH from the front disc brake pad.

  3. REMOVE FRONT DISC BRAKE ANTI-SQUEAL SHIM


    1. B006EU2C02
      *1 Front Disc Brake Pad
      *2 No. 1 Anti-Squeal Shim
      *3 No. 2 Anti-Squeal Shim
      *4 Inner Anti-Rattle Spring

      Remove the No. 1 and No. 2 anti-squeal shims from each of the front disc brake pads.

    2. Remove the inner anti-rattle springs from each of the front disc brake pads.