SWITCH HOUSING REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the steering wheel switch housing removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Removal/installation of the spiral cable with sensor sub-assembly

  • Steering angle neutral point (Initialize parking assist monitor system)

  • Steering angle setting

 Parking assist monitor system

for Initialization

Click here

for Calibration

Click here

Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B0084SX

Click here

PROCEDURE


  1. REMOVE SPIRAL CABLE WITH SENSOR SUB-ASSEMBLY

    Click here

  2. REMOVE TILT AND TELESCOPIC SWITCH (for Power Tilt and Power Telescopic Steering Column)

    Click here

  3. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

    Click here

  4. REMOVE TURN SIGNAL SWITCH

    Click here

  5. REMOVE STEERING WHEEL SWITCH HOUSING


    1. B0087B9

      Using pliers, expand the clamp as shown in the illustration.

    2. B0087CAC01
      *a Protective Tape
      B00847Z Remove in this Direction

      While holding the clamp expanded, using a screwdriver with its tip wrapped with protective tape, disengage the claw and remove the steering wheel switch housing as shown in the illustration.