REAR VIEW MONITOR SYSTEM(w/ Side Monitor System) DTC CHECK / CLEAR

  1. CHECK DTC

    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Chassis / Parking Assist Monitor System / Trouble Codes.

    5. Check the details of the DTCs (Click hereClick hereClick here).

      Tip:

      The parking assist ECU may store the DTCs of the following system. If DTCs other than those specified in Diagnostic Trouble Code Chart of the rear view monitor system are output, refer to Diagnostic Trouble Code Chart for the applicable system.

      System

      Proceed to

      Side Monitor System (w/ Rear View Monitor System)

      Click here

  2. CLEAR DTC

    1. Connect the intelligent tester to the DLC3.

    2. Turn the engine switch on (IG).

    3. Turn the intelligent tester on.

    4. Enter the following menus: Chassis / Parking Assist Monitor System / Trouble Codes.

    5. According to the display on the intelligent tester, select the trouble code data display with the clear button.

      Chassis > IPA/Parking Assist Monitor > Clear DTCs