PRE-COLLISION SYSTEM DIAGNOSIS SYSTEM


  1. CHECK DLC3


    1. Check the DLC3.

      Click here

  2. FUNCTION OF WARNING INDICATOR AND MESSAGE


    1. If the pre-collision system is not functioning properly, the driver is warned by the PCS warning light and a warning message displayed on the multi-information display.

      Master Warning Indicator Warning Message Detail DTC PCS warning light
      Illuminated "Pre-Collision System Malfunction Visit Your Dealer" is displayed Pre-collision system malfunctioning Stored Blinks
      Not illuminated "Pre-Collision System Unavailable"

      • Millimeter wave radar sensor assembly misaligned

      • Millimeter wave radar sensor assembly temperature malfunction

      • Millimeter wave radar sensor assembly low voltage malfunction

      		 Not stored Blinks
      Not illuminated "Pre-Collision System Unavailable Clean Sensor" Foreign matter attached to millimeter wave radar sensor assembly Not stored Blinks
      Not illuminated "Front Camera Unavailable"

      • Abnormal forward recognition camera voltage

      • Forward recognition camera temperature outside of operational range

      • Other forward recognition camera malfunction

      		 Not stored Blinks
      Not illuminated "Front Camera Vision Blocked Clean and Demist Windshield"

      • Forward recognition camera is dirty or fogged up

      • The windshield glass of the lens in the forward recognition camera is dirty or fogged up

      		 Not stored Blinks
      Not illuminated "VSC Turned Off Pre-Collision Brake System Unavailable" VSC system is disabled Not stored Illuminates

      Tech Tips

      PCS Warning Light Illumination Status
      PCS Warning Light Condition
      Blinks ON: 0.5 sec./OFF: 1.5 sec. Pre-collision system malfunctioning (DTC stored)
      Pre-collision system temporarily disabled
      Illuminates Pre-collision system disabled
      VSC system disabled
      Not illuminated Other

  3. INITIAL CHECK


    1. An initial check is performed when the engine switch is off for more than 2 seconds and then turned on (IG). The initial check consists of a pre-collision system diagnostic check with a duration of approximately 3 seconds.

    2. If a malfunction is detected during the initial check, the PCS warning light in the combination meter assembly will blink and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.

  4. CONSTANT CHECK


    1. The driving support ECU assembly constantly monitors the pre-collision system for malfunctions after the engine switch is turned on (IG) and the initial check (approximately 3 seconds) has completed.

    2. If a malfunction is detected during the constant check, the PCS warning light in the combination meter assembly will blink and a warning message indicating the pre-collision system is malfunctioning or disabled will be displayed on the multi-information display.