GENERATOR INSTALLATION

PROCEDURE

  1. INSTALL GENERATOR ASSEMBLY

    1. A196712

      Install the generator assembly with the 3 bolts.

      25 N*m

      255 kgf*cm

      18 ft.*lbf

      Note:

      Make sure that the wire harness of the crankshaft position sensor does not get caught between the cylinder block and the generator when installing the generator assembly.

    2. A210427

      Connect the wire harness to terminal B and install the nut and bolt.

      Nut

      9.8 N*m

      100 kgf*cm

      87 in.*lbf

      Bolt

      8.4 N*m

      86 kgf*cm

      74 in.*lbf

    3. Connect the connector.

    4. Install the terminal cap.

  2. INSTALL V-RIBBED BELT

    Click here

  3. INSTALL FRONT DRIVE SHAFT ASSEMBLY RH

    Click here

  4. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick here