ENGINE COOLANT TEMPERATURE SENSOR REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    CAUTION:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.

  2. DRAIN ENGINE COOLANT


    1. Remove the radiator cap.

    2. Loosen the cylinder block drain cock plug and radiator drain cock plug, and then drain the coolant.

      Tech Tips

      Collect the coolant in a container and dispose of it according to the regulations in your area.

      A01DZG1E01

  3. REMOVE INTAKE AIR CONNECTOR


    1. Disconnect the vacuum hose.

    2. Disconnect the No. 2 ventilation hose.

    3. Loosen the hose clamp, and remove the 2 bolts and intake air connector.

  4. REMOVE STARTER ASSEMBLY


    1. A01E2ARE01

      Disconnect the starter connector.

    2. Disconnect the terminal cap.

    3. Remove the nut and disconnect the starter wire.

    4. Remove the 2 bolts and starter.

  5. REMOVE THROTTLE BODY


    1. Disconnect the throttle position sensor and control motor connector.

    2. Disconnect the 2 water by-pass hoses.

    3. A01E2X8

      Remove the 4 bolts and throttle body.

    4. Remove the gasket.

  6. REMOVE INTAKE MANIFOLD


    1. A01DXPDE03

      Disconnect the vacuum hose.

    2. Disconnect the VSV hose and connector for EVAP.

    3. Remove the 5 bolts, 2 nuts, intake manifold and gasket.

  7. REMOVE ENGINE COOLANT TEMPERATURE SENSOR


    1. A01E0VM

      Disconnect the sensor connector.

    2. Remove the sensor.

    3. Remove the gasket from the sensor.