FRONT CRANKSHAFT OIL SEAL REMOVAL

PROCEDURE

1. REMOVE V-RIBBED BELT

   Click hereClick here

2. REMOVE FRONT SUSPENSION MEMBER REINFORCEMENT RH

   Click hereClick here

3. REMOVE CRANKSHAFT PULLEY

   Tip:

   For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

   1. 

      *a	Hold
      *b	Turn

      Using SST, hold the crankshaft pulley in place and loosen the pulley bolt.

      for 86 mm (3.39 in.) Bolt Pitch Type:

      09213-58014

      91551-80840

      09330-00021

      for 64 mm (2.52 in.) Bolt Pitch Type:

      09213-54015

      09330-00021

      Tip:

      For the 64 mm (2.52 in.) bolt pitch type, the part number of the installation bolt for SST (crankshaft pulley holding tool) is 91551-00850 (quantity: 2).

   2. 

      *a	Hold
      *b	Turn

      Using SST, remove the crankshaft pulley and pulley bolt.

      09950-50013

      09951-05010

      09952-05010

      09953-05020

      09954-05021

4. REMOVE TIMING CHAIN COVER OIL SEAL

   1. Using a knife, cut off the lip of the timing chain cover oil seal.

   2. 

      *a	Protective Tape
      *b	Cut Position

      Using a screwdriver with its tip wrapped with protective tape, pry out the timing chain cover oil seal.

      Note:

      After removing, check the crankshaft and timing chain cover sub-assembly for damage. If damaged, smooth the surface with 400-grit sandpaper.