RELAY ON-VEHICLE INSPECTION

PROCEDURE

  1. INSPECT DOME CUT RELAY

    1. E222294C13

      *a

      Component without harness connected

      (DOME CUT Relay)

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection

      Condition

      Specified Condition

      3 - 5

      Battery voltage not applied between terminals 1 and 2

      10 kΩ or higher

      3 - 5

      Battery positive (+) → 2

      Battery negative (-) → 1

      Below 1 Ω

      If the result is not as specified, replace the DOME CUT relay.