GLOW PLUG REMOVAL

PROCEDURE


  1. PRECAUTION

    Note

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  3. REMOVE INTAKE PIPE


    1. B0024LC

      Remove the 2 bolts.

    2. Loosen the 2 hose clamps and remove the intake pipe.

  4. REMOVE NO. 1 GLOW PLUG CONNECTOR


    1. B00275SC01
      *1 Nut
      *2 Plate Washer
      *3 No. 2 Glow Plug Resistor Insulator
      *4 Wire Harness
      *5 No. 1 Glow Plug Resistor Insulator

      Remove the nut, plate washer and No. 2 glow plug resistor insulator and disconnect the wire harness.

    2. Remove the 4 screw grommets, 4 nuts and No. 1 glow plug connector.

    3. Remove the No. 1 glow plug resistor insulator.

  5. REMOVE GLOW PLUG ASSEMBLY

    B0028M9

    1. Using a 12 mm deep socket wrench, remove the 4 glow plug assemblies.