REAR CROSSING TRAFFIC ALERT BUZZER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during the blind spot monitor buzzer removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision System
Initialize back door lock Initialize back door lock

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

CAUTION:

Some of these service operations affect the SRS airbag system. Read the precautionary notices concerning the SRS airbag system before servicing.

B008KCO

Click here

Tech Tips


  • Use the same procedure for LHD and RHD vehicles.

  • The procedure listed below is for the LHD vehicles.

PROCEDURE


  1. REMOVE LOWER NO. 1 INSTRUMENT PANEL AIRBAG ASSEMBLY (for LHD with Driver Side Knee Airbag)

    Click here

  2. REMOVE FUSE BOX OPENING COVER (for LHD without Driver Side Knee Airbag)

    Click here

  3. REMOVE GLOVE COMPARTMENT DOOR ASSEMBLY (for RHD)

    Click here

  4. REMOVE BLIND SPOT MONITOR BUZZER


    1. A001SFP

      for LHD:


      1. Using a clip remover, disengage the clamp.

      2. Disconnect the connector to remove the blind spot monitor buzzer.

    2. A001XAT

      for RHD:


      1. Using a clip remover, disengage the clamp.

      2. Disconnect the connector to remove the blind spot monitor buzzer.