STARTER REMOVAL

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.

    Click hereClick hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick here

  3. DISCONNECT CABLE FROM POSITIVE BATTERY TERMINAL

  4. REMOVE NO. 1 ENGINE UNDER COVER

    Click hereClick hereClick hereClick hereClick here

  5. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  7. REMOVE BATTERY CLAMP SUB-ASSEMBLY

    1. A296336

      Remove the bolt and loosen the nut.

    2. Detach the hook of the battery clamp sub-assembly from the front battery bracket, and then remove the battery clamp sub-assembly.

  8. REMOVE BATTERY

  9. REMOVE BATTERY TRAY

  10. DISCONNECT RADIATOR HOSE SUB-ASSEMBLY

    1. A296337

      Remove the 2 bolts and disconnect the radiator hose sub-assembly from the front battery bracket.

  11. REMOVE FRONT BATTERY BRACKET

    1. A300697

      Detach the 3 wire harness clamps.

    2. A296338

      Remove the 4 bolts and front battery bracket.

  12. REMOVE BATTERY BRACKET REINFORCEMENT

    1. A296339

      Remove the 2 bolts and battery bracket reinforcement.

  13. DISCONNECT TRANSMISSION CONTROL CABLE ASSEMBLY (for CVT)

    1. A296340

      Remove the clip and disconnect the transmission control cable assembly from the No. 1 transmission control cable bracket.

  14. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET (for CVT)

    Click here

  15. REMOVE STARTER ASSEMBLY

    1. A211434

      Disconnect the terminal cap.

    2. Remove the nut and disconnect the starter wire.

    3. Disconnect the starter connector.

    4. Remove the 2 bolts and starter assembly.

  16. REMOVE FLYWHEEL HOUSING SIDE COVER

    1. A207285

      Remove the flywheel housing side cover from the cylinder block.