SHIFT PADDLE SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the engine switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

PROCEDURE


  1. INSTALL NO. 1 SWITCH WIRE


    1. Connect the 2 guides and install the No. 1 switch wire to the lower steering wheel boss cover.

      B006D6MC02
      *a No. 1 Switch Wire Harness Junction *b No. 1 Switch Wire Blue Connector
      *c Front Side *d Back Side

      Note


      • Install the No. 1 switch wire harness junction so that it is inside the left guide as shown in the illustration.

      • Install the blue connector of the No. 1 switch wire to the transmission shift switch LH.

  2. INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY


    1. for transmission shift switch assembly LH side:


      1. B006GEY

        Connect the connector of the No. 1 switch wire to the transmission shift switch assembly.

      2. B006DXVC01
        *a Protrusion
        *b Guide

        Align the 3 protrusions on the transmission shift switch assembly with the 3 guides on the steering wheel assembly and lower steering wheel boss cover.

      3. B006BY3C01
        *1 Transmission Shift Switch Assembly
        *2 No. 1 Switch Wire
        *a Guide
        B006DHE Push in perpendicular

        Push in the transmission shift switch assembly into the steering wheel assembly perpendicular, attach the 2 claws and No. 1 switch wire to the guide and install the transmission shift switch assembly to the steering wheel assembly.

    2. for transmission shift switch assembly RH side:


      1. B006AWT

        Connect the connector of the No. 1 switch wire to the transmission shift switch assembly.

      2. B006A4TC01
        *a Protrusion
        *b Guide

        Align the 3 protrusions on the transmission shift switch assembly with the 3 guides on the steering wheel assembly and lower steering wheel boss cover.

      3. B006G23C01
        *1 Transmission Shift Switch Assembly
        *2 No. 1 Switch Wire
        *a Guide
        B006DHE Push in perpendicular

        Push in the transmission shift switch assembly into the steering wheel assembly perpendicular, attach the 2 claws and No. 1 switch wire to the guide and install the transmission shift switch assembly to the steering wheel assembly.

    3. Check the installation condition of the No. 1 switch wire.

      B006COTC01
      *a OK *b NG
      *c Does not protrude - -

      Note

      Make sure that the No. 1 switch wire does not stick out from the lower steering wheel boss cover.

    4. B006EY1

      Connect the 2 transmission shift switch assemblies with the 2 screws.

  3. INSTALL STEERING PAD SWITCH ASSEMBLY

    Click here

  4. INSTALL STEERING WHEEL ASSEMBLY

    Click here