DIFFERENTIAL PRESSURE SENSOR(w/o Glow Plug Controller) REMOVAL

PROCEDURE

1. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

   Click hereClick here

2. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

   Click here

3. REMOVE WATER GUARD PLATE LH (for LHD)

   • for Sedan:

     Click hereClick hereClick here

   • for Hatchback, Wagon:

     Click hereClick hereClick here

4. REMOVE WATER GUARD PLATE LH (for RHD)

   • for Sedan:

     Click here

   • for Hatchback, Wagon:

     Click here

5. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)

   • for Sedan:

     Click hereClick hereClick here

   • for Hatchback, Wagon:

     Click hereClick hereClick here

6. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)

   • for Sedan:

     Click here

   • for Hatchback, Wagon:

     Click here

7. REMOVE OUTER COWL TOP PANEL (for LHD)

   • for Sedan:

     Click hereClick hereClick here

   • for Hatchback, Wagon:

     Click hereClick hereClick here

8. REMOVE OUTER COWL TOP PANEL (for RHD)

   • for Sedan:

     Click here

   • for Hatchback, Wagon:

     Click here

9. REMOVE DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

   1. 

      Disconnect the connector from the differential pressure sensor assembly.

   2. 

      Remove the bolt and separate the differential pressure sensor assembly.

   3. 

      *1	Vacuum Transmitting Hose Assembly
      *2	No. 2 Vacuum Transmitting Hose Assembly

      Slide the 2 clips and disconnect the vacuum transmitting hose assembly and No. 2 vacuum transmitting hose assembly from the differential pressure sensor assembly.