PARK / NEUTRAL POSITION SWITCH REMOVAL


  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

  2. REMOVE FRONT EXHAUST PIPE ASSEMBLY (w/ DPF)


    1. Disconnect the exhaust gas temperature sensor connector and detach the clamp.

    2. Disconnect the No. 2 exhaust gas temperature sensor connector and detach the 2 clamps.

    3. Disconnect the No. 3 exhaust gas temperature sensor connector and detach the 2 clamps.

    4. B007T94

      Disconnect the No. 1 exhaust pipe air hose and No. 7 exhaust pipe air hose from the front exhaust pipe.

    5. B007U9D

      Remove the 2 No. 4 exhaust pipe supports.

    6. Remove the 3 nuts and front exhaust pipe.

    7. Remove the gasket.

  3. SEPARATE TRANSMISSION CONTROL CABLE ASSEMBLY


    1. Set the shift lever to the neutral position.

    2. B007UJWE01

      Remove the nut from the control shaft lever.

    3. Remove the clip and disconnect the control cable from the control cable bracket.

  4. REMOVE PARK/NEUTRAL POSITION SWITCH ASSEMBLY


    1. B007OM3E01

      Disconnect the park/neutral position switch connector.

    2. B007QO5E03

      Using a screwdriver, pry out the lock washer.

    3. Remove the lock nut and lock washer.

    4. B007V6Y

      Remove the bolt and park/neutral position switch.

      Tech Tips

      Make sure that the manual valve lever shaft has not been rotated prior to installing the park/neutral position switch as the detent spring may become detached from the manual valve lever shaft.