DIFFERENTIAL PRESSURE SENSOR REMOVAL

PROCEDURE

  1. REMOVE NO. 1 ENGINE COVER (w/ No. 1 Engine Cover)

    Click here

  2. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

    Click here

  3. REMOVE WATER GUARD PLATE LH (for LHD)

    Click here

  4. REMOVE WATER GUARD PLATE LH (for RHD)

    Click here

  5. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for LHD)

    Click here

  6. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL (for RHD)

    Click here

  7. REMOVE OUTER COWL TOP PANEL

    Click here

  8. REMOVE DIFFERENTIAL PRESSURE SENSOR ASSEMBLY

    1. A199667

      Disconnect the connector from the differential pressure sensor assembly.

    2. A199754

      Remove the bolt and separate the differential pressure sensor assembly.

    3. A199755C01

      *1

      Vacuum Transmitting Hose Assembly

      *2

      No. 2 Vacuum Transmitting Hose Assembly

      Slide the 2 clips and disconnect the vacuum transmitting hose assembly and No. 2 vacuum transmitting hose assembly from the differential pressure sensor assembly.