HEADLIGHT CLEANER ACTUATOR REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during headlight washer actuator sub-assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front bumper assembly Front television camera view adjustment Panoramic view monitor system

Click here for Initialization

Click here for Calibration
Front bumper assembly (w/ Intelligent clearance sonar system)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

  • Intelligent clearance sonar system

  • LEXUS parking assist-sensor system

Click here

PROCEDURE


  1. REMOVE FRONT BUMPER ASSEMBLY

    Click here

  2. REMOVE HEADLIGHT WASHER COVER LH

    Click here

  3. REMOVE HEADLIGHT WASHER COVER RH

    Tech Tips

    Use the same procedure as for the LH side.

  4. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY LH


    1. B007ZWNC02
      B007WXX Push
      B007Z37 Disconnect in this Direction

      Disengage the claw and disconnect the No. 4 headlight cleaner hose as shown in the illustration.

    2. B007Z2L

      Remove the screw.

    3. Disengage the claw and guide as indicated by the arrows, in the order shown in the illustration to remove the headlight washer actuator sub-assembly LH.

      B007YMWC02
      B007Z37 Remove in this Direction (1) B007YXL Remove in this Direction (2)
      B00803U Remove in this Direction (3) - -

  5. REMOVE HEADLIGHT WASHER ACTUATOR SUB-ASSEMBLY RH

    Tech Tips

    Use the same procedure as for the LH side.