REAR CRANKSHAFT OIL SEAL INSTALLATION

PROCEDURE


  1. INSTALL REAR ENGINE OIL SEAL


    1. Clean the oil seal retainer oil seal contact surface of the crankshaft.

    2. Apply MP grease to the lip of a new rear engine oil seal.

      Note


      • Do not allow foreign matter to contact the lip of the timing chain case oil seal.

      • Do not allow MP grease to contact the dust seal.

    3. B006AE9C02
      *a Oil Seal Protrusion Height

      Using SST and a hammer, tap in the rear engine oil seal.

      SST
      09223-56010
      Oil Seal Protrusion Height
      0 to 0.5 mm (0 to 0.0197 in.)

      Note


      • Do not tap the rear engine oil seal at an angle.

      • Keep the lip free of foreign matter.

  2. INSPECT DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. for 2WD:

      Click here

    2. for AWD:

      Click here

  3. INSTALL DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    1. B006DNTN02

      Using SST, hold the crankshaft pulley.

      SST
      09213-54015   ( 09213-70020 )
      09330-00021

    2. Clean the 10 bolt holes.

    3. B006DXLC02
      *a Pin Hole
      *b Pin
      B006AHR Engine Front

      Install the crankshaft angle sensor rotor.

      Tech Tips

      Align the pin hole of the crankshaft angle sensor rotor with the pin of the crankshaft.

    4. B006GGWC02
      *1 Drive Plate and Ring Gear Sub-assembly
      *2 Rear Drive Plate Spacer
      B006AHR Engine Front

      Install the drive plate and ring gear sub-assembly and rear drive plate spacer onto the crankshaft.

      Tech Tips

      As the drive plate and ring gear sub-assembly and the rear drive plate spacer are not reversible, be sure to install them so that they are facing in the direction shown in the illustration.

    5. B006FDHC92
      *a Adhesive

      Apply a few drops of adhesive to 2 or 3 threads at the tip of each of 10 new bolts.

      Adhesive
      Toyota Genuine Adhesive 1324, Three Bond 1324 or equivalent

      Note

      After applying the adhesive, tighten the bolt right away.

    6. B0069SFN01

      Install and uniformly tighten the 10 new bolts in the sequence shown in the illustration.

      Torque:
      29.5 N*m  { 301 kgf*cm, 22 ft.*lbf }

      Note


      • Do not reuse the drive plate installation bolts.

      • Handle the drive plate installation bolts carefully. Do not scratch them or subject them to any shocks.

      • Do not start the engine for at least 1 hour after installing the drive plate and ring gear sub-assembly.

    7. B006CR3C03
      *a Paint Mark
      *b 90°
      B006EC9 Up

      Mark the top of the bolts with paint.

    8. Tighten the 10 bolts 90° in the same sequence.

    9. Check that the paint marks are now at a 90° angle to the top.

  4. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY WITH TRANSFER (for AWD)

    Click here

  5. INSTALL AUTOMATIC TRANSMISSION ASSEMBLY (for 2WD)

    Click here

  6. INSPECT FOR OIL LEAK

    Click here