FRONT LOWER BALL JOINT(for AWD) REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH side.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE STEERING KNUCKLE LH

    Click here

  2. DISCONNECT LOWER NO.2 SUSPENSION ARM ASSEMBLY LH

    Click here

  3. REMOVE FRONT LOWER BALL JOINT ASSEMBLY LH


    1. B006BA0

      Remove the clip and nut.

    2. Install SST (attachment) onto the front lower ball joint assembly LH so that there is a space of approximately 2 mm (0.0787 in.) between the arm and attachment.

      SST
      09628-50010   ( 09628-05010 )
      B006AYXC01
      *a 2 mm (0.0787 in.) - -

      Note


      • Be sure to install SST (attachment) in order to prevent damage to the front lower ball joint assembly LH stud.

      • As SST may become damaged, make sure the space between the arm and spacers is not 2 mm (0.0787 in.) or less.

    3. Using SST, disconnect the front lower ball joint assembly LH from the front lower suspension arm assembly LH.

      SST
      09628-50010   ( 09628-05010 )

      Note


      • Apply molybdenum grease to the bolt threads and end of the SST bolt.

      • Do not damage the dust cover of the front lower ball joint assembly LH.

      • Make sure that the bolt of SST and the front lower ball joint assembly LH are in a straight line when installing SST.

      • Be sure to tie the string of SST to the vehicle to prevent SST from dropping.

      • Do not apply a torque of 160 N*m (1631 kgf*cm, 118 ft.*lbf) or more to SST as it may be damaged.