HEIGHT CONTROL SENSOR INSPECTION

PROCEDURE

  1. INSPECT REAR HEIGHT CONTROL SENSOR

    1. Check the rear height control sensor.

      C260553C01

      *A

      for RH

      *B

      for LH

      *a

      Component without harness connected

      (Rear Height Control Sensor)

      *b

      Vehicle Height: Low

      *c

      Normal

      *d

      Vehicle Height: High

      1. Connect 3 dry cell batteries of 1.5 V in series.

      2. Connect the positive (+) end of the batteries to terminal 1 (SHB) of the height control sensor and the negative (-) end of the batteries to terminal 3 (SHG). While slowly moving the sensor link up and down, measure the voltage according to the value(s) in the table below.

        Standard Voltage

        Table 1. for RH

        Tester Connection

        Sensor Condition

        Specified Condition

        3 (SHG) - 2 (SHRR)

        High (45°)

        4.4 to 4.6 V

        Normal (0°)

        2.3 to 2.6 V

        Low (-45°)

        0.4 to 0.6 V
        Table 2. for LH

        Tester Connection

        Sensor Condition

        Specified Condition

        3 (SHG) - 2 (SHRL)

        High (45°)

        4.4 to 4.6 V

        Normal (0°)

        2.3 to 2.6 V

        Low (-45°)

        0.4 to 0.6 V
        Note:

        Do not apply higher than 6 V.

        If the result is not as specified, replace the height control sensor.