RAIN SENSOR INSTALLATION

PROCEDURE

1. INSTALL RAIN SENSOR TAPE

   Tip:

   Rain sensor tape is reusable. Only replace the tape if it is damaged or contaminated.

   1. Clean the rain sensor sensing portion with a piece of cloth, etc.

   2. 

      Rain Sensor Tape

      Peel off the smaller release sheet, and then engage the rain sensor tape on the rain sensor sensing portion as shown in the illustration.

      Standard Clearance

      Area	Measurement
      A	7.25 mm (0.285 in.)
      B	13.5 mm (0.531 in.)

      Note:

      Use your fingers to push out any air bubbles from under the tape.

2. INSTALL RAIN SENSOR

   1. Clean the windshield glass with a piece of cloth, etc.

      Note:

      • Make sure that there is no rain sensor tape residue remaining on the windshield glass. If there is, remove the residue.

      • If there is any rain sensor tape residue remaining on the windshield glass, replace the tape.

   2. When installing a new rain sensor or replacing the rain sensor tape:

      1. Peel off the release sheet.

         Tip:

         Do not touch the silicone coated surfaces.

   3. 

      *a

      Stopper

      Gradually engage the rain sensor to the glass surface to prevent air bubbles from forming between them.

      Tip:

      Do not touch the silicone coated or glass surfaces.

   4. Push in the stopper.

   5. Connect the connector.

3. INSTALL RAIN SENSOR COVER

   1. Engage the 2 claws and connect the rain sensor cover.

   2. 

      Engage the 2 guides and install the rain sensor cover as shown in the illustration.