FRONT DRIVE SHAFT ASSEMBLY(for 1NR-FE) REMOVAL

CAUTION / NOTICE / HINT

PROCEDURE

1. REMOVE FRONT WHEELS

2. REMOVE NO. 1 ENGINE UNDER COVER (for Metal Type)

3. REMOVE REAR ENGINE UNDER COVER LH

4. REMOVE REAR ENGINE UNDER COVER RH

5. DRAIN MANUAL TRANSAXLE OIL

   Click here

6. REMOVE FRONT AXLE SHAFT NUT

   1. 

      Using SST and a hammer, release the staked part of the front axle shaft nut.

      09930-00010

      Note:

      Loosen the staked part of the nut completely, otherwise the threads of the drive shaft may be damaged.

   2. While applying the brakes, remove the front axle shaft nut.

7. SEPARATE FRONT SPEED SENSOR

   Click hereClick hereClick here

8. SEPARATE FRONT FLEXIBLE HOSE

   Click hereClick hereClick here

9. SEPARATE TIE ROD END SUB-ASSEMBLY

   Click here

10. SEPARATE FRONT STABILIZER LINK ASSEMBLY

    Click hereClick here

11. SEPARATE FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY

    Click hereClick hereClick here

12. SEPARATE FRONT DRIVE SHAFT ASSEMBLY

    Click hereClick hereClick here

13. REMOVE FRONT DRIVE SHAFT ASSEMBLY LH

    1. 

       Using SST, remove the front drive shaft assembly LH.

       09520-01010

       09520-24010

       09520-32040

       Note:

       • Do not damage the transmission case oil seal.

       • Do not damage the front axle inboard joint boot.

       • Do not drop the front drive shaft assembly LH.

14. REMOVE FRONT DRIVE SHAFT ASSEMBLY RH

    Tip:

    Perform the same procedure as for the LH side.

15. REMOVE FRONT DRIVE SHAFT HOLE SNAP RING LH

    1. 

       Using a screwdriver, remove the front drive shaft hole snap ring.